CYBEX Sirona Gi i-Size Manual Del Usuario página 7

CERTIFICATION
EN
Sirona Gi i-Size
UN R129/03
with Newborn inlay
Size range: 40 – 105 cm
Thank you for choosing the Sirona Gi i-Size newborn inlay (1).
Carefully read this user guide before installing the newborn inlay (1) on the
Sirona Gi i-Size car seat. Always keep the guide to hand in the designated
compartment of the Sirona Gi i-Size.
The usage of this newborn inlay (1), as well as the enclosed optional additional
insert (comfort inlay) (2), is permitted with the CYBEX Sirona Gi i-Size car
seat only.
PRODUCT PARTS
Newborn inlay (1)
Optional additional insert (2)
Shoulder belts (3)
Belt buckle (4)
Headrest of the newborn inlay (5)
Side pads of the newborn inlay (6)
Lap belts (7)
Seat surface of the newborn inlay (8)
4
SIRONA GI I-SIZE
i-Size universal ISOFIX
40–105 cm
max. 20 kg
030093
UN Regulation No. 129/03
Cybex GmbH
Riedingerstr. 18, 95448 Bayreuth
Germany
OVERVIEW
40 – 48 cm
48 – 60 cm
61 – 105 cm
INSTALLATION OF THE OPTIONAL ADDITIONAL INSERT
The package contains an optional additional insert (2) for small Newborns. It is
designed to improve the seating position of premature and newborn children. It
must be removed from the child seat once the child reaches a height of
48 cm. If your baby is above 48 cm when first using the car seat, the insert is
not needed and you can directly proceed reading the chapter "Installation of
the newborn inlay".
1. To use the optional additional insert (2) with the child seat loosen the
Shoulder belts (3) and open the Belt buckle (4).
2. Move the headrest into a higher position.
3. Put the optional additional insert (2) onto the seating surface below the soft
goods cover after flipping the cover to the front.
4. Put the cover back and push it into the gap behind the optional additional
insert (2).
5. Adjust the headrest to the lowest position. Make sure that it is guided
behind the optional additional insert (2).
6. Now take the newborn inlay (1) and place it in the child seat as described
in the chapter "Installation of the newborn inlay".
The optional additional insert must only be used in combination with the
��
newborn inlay.
The optional additional insert must be removed after the child exceeds a
��
height of 48 cm.