cecotec Conga Rockstar 300 X-Treme ErgoWet Manual De Instrucciones página 27

7. WET ACCESSORY
BEFORE USE
1. Take the product out of the box.
2. Remove all packaging materials. Keep the original box.
3. Make sure all the components are included and in good conditions, otherwise, contact
immediately the official Technical Support Service of Cecotec.
4. When you do not use the vacuum cleaner for a long time, please remove the water tank
and empty the remaining water. Do not expose to direct sunlight or damp environments.
MOP INSTALLATION/REMOVAL
Removing/installing the water tank
• In order to install/remove the cleaning cloth you must first disassemble the water tank
from the rest of the appliance.
• In order to remove the water tank, use your foot to hold it against the
ground and pull upwards until it unclicks from position.
• Once the cloth has been installed and the water tank has been filled,
to reinstall the water tank, simply push it back together until it clicks
into position.
Note: Do not use cleaning agents. Use clean and room temperature water
only. Do not use the vacuum cleaner to vacuum water.
Installing the mop cloth
• Place the mop cloth on the ground with the Velcro facing
upwards.
• Align the mop cloth with the Velcro strips on the water tank and
attach it.
Water emission
• When using this product for the first time, make sure the water
tank lid is not fully open. When not in use, pay attention to this
water emission push button and to the tank lid, as water leak may
occur when the water tank is full and the product is not in use.
• To activate water emission, the water emission push button must
be pressed, and to stop water emission, the push button must be released as shown on
the following figure:
Water emission
CONGA ROCKSTAR 300 X-TREME ERGOWET
ENGLISH
Water closed
27