Worx WX170 Manual Original página 12

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for driving in and loosening screws as well as for drilling in wood,
metal and plastic.
ASSEMBLY AND OPERATION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and disconnect tool from power source when
changing accessories. Always ensure the bit is secure before starting the tool. Damage to the
12
Chuck or a loose bit may cause possible personal injury.
--Removing the bits
--Inserting the bits
OPERATION
FORWARD/REVERSE ROTATION CONTROL
WARNING: Never change the direction of rotation when the chuck
is rotating, wait until it has stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
DRILLING,SCREWDRIVING
OPERATING THE ON/OFF SWITCH
WARNING: Do not operate for long periods at low speed
because excess heat will be produced internally.
Lithium-Ion Cordless Drill/Driver
ACTION FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig. C1, C2, C3
See Fig. D
See Fig. E
See Fig. F
EN