Worx WX170 Manual Original página 13

LED LIGHT INDICATOR
Before operation, the LED light will be activated when the On/Off switch is slightly depressed.
WARNING: To turn on the light, press the On/Off switch and make sure the Forward/Reverse
Rotation Control is on right/left position.
The tool and battery are equipped with a protection system. When the LED Light is quickly flashing
60 seconds and turn off, the system will automatically cut off power to the tool to extend battery
life. The tool will automatically stop during operation if the tool and/or battery are placed under one
of the following conditions:
• Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current.
In this situation, release the Trigger Switch on the tool and stop the application that caused the tool
to become overloaded. Then pull the Trigger Switch again to restart.
• Overheated: Under the condition above, if the tool does not start, the Tool and Battery are
overheated. In this situation, let the Tool and Battery cool before pulling the Trigger Switch again.
• Low battery voltage: The remaining Battery capacity is too low and the tool will not operate. In
this situation, remove and recharge the Battery.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is
on top of the trigger, is positioned in the lock
function. Unlock the forward/reverse rotation
control by putting it into the required rotation
position. Push the trigger and the drill will
start to rotate.
2. THE DRILL STOPS BEFORE THE
SCREW IS COMPLETELY TIGHTENED.
WHY?
Verify the torque position of the torque
adjusting ring, you can find the torque-
adjusting ring between the chuck and the drill
body. Position 1 is the lowest torque (screw
driving force) and position 15 is the highest
torque (screw driving force). Position
drill operation. Regulate the torque adjusting
ring to a higher position to reach the best
result.
Lithium-Ion Cordless Drill/Driver
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and
having not used a battery pack for a
prolonged time will reduce the battery pack
working time. This can be corrected after
several charge and discharge operations by
charging & working with your drill. Heavy
working conditions such as large screws
into hard wood will use up the battery pack
energy faster than lighter working conditions.
Do not re-charge your battery pack below
0°C and above 45°C as this will affect
performance.
is for
13
EN