Lenco DAR-251 Manual De Usuario página 11

Display Backlight
You can press the DIMMER button adjust the display backlight brightness, there are 3 options available,
High, Medium and Low.
DAB Radio mode
Carefully extend the telescopic antenna.
Press the POWER button to turn on the unit, it will start up into DAB mode.
Auto Scan
1. If this is the first time the unit has entered DAB Mode, it will automatically start an 'Auto Scan' to
search for available stations. (Once DAB Mode has been used before, the unit will automatically
select the previously played station)
2. Hold the ENTER button to automatically start auto scan to search for available stations. During the
scanning process, the lower line of the display shows a bar graph indicating the progress of the
scan.
Manual Scan
1. Press the MENU key on main unit to enter the menu.
2. Press the [] or [] button to select "Manual tune", press the [ENTER] button to the submenu.
3. Press the [] or [] enter to tune in the desired channel. A graph will indicate the signal
strength if you press [ENTER]
4. Press [MENU] or [
5. If no stations are found, please ensure the aerial is extended and test the reception by doing
another auto scan in a different location.
DRC (Dynamic Range Control)
Dynamic Range Control (also known as DRC) is a technology used to help make quieter sounds easier
to hear in a noisy environment.
1. In DAB menu, press the [] or [] button to select "DRC", press the [ENTER] button to display
"*" to the top right.
2. DRC OFF - DRC is switched off, broadcast DRC will be ignored.
DRC LOW - DRC level is set to 1/2 that sent by broadcaster.
DRC HIGH - DRC level is used as sent by broadcaster.
Press MENU to confirm the setting. The display will return to normal.
] to exit scan.
- EN 11 -