MPM MSO-16 Manual De Instrucciones página 41

ASSEMBLING THE JUICER
14
11
A
B
Place the rubber stopper (14) in the hole under the filter bowl (5). Place the sealing
1
sleeve (11) in the filter bowl (5), if not assembled already.
Place the appliance on a smooth, stable and level surface. Install the filter bowl (5) on
the motor unit (1) by locating the 3 bosses (B) on the housing top in the 3 grooves (A) on
2
the filter bowl bottom (5). The grooves (A) will match the bosses (B) in a single specific
alignment of the two parts. Next, place the plug onto the juice spout opening.
Install the the automatic cleaning module (10) onto the mesh filter basket (9). Use a
3 small mesh filter basket (9a) or a large mesh filter basket (9b), depending on how thick
you want your juice.
Insert and adjust the stainless steel mesh filter basket (9) with the automatic cleaning
module (10) in the filter bowl (5) so that the tab on the filter basket engages the filter
4
bowl groove (5) and the white marks on the filter basket (9) and filter bowl (5) are
aligned.
5 Place the extraction screw (8) in the filter basket (9).
EN
41