Makita DLM464 Manual De Instrucciones página 15

To remove the battery cartridge from the mower;
1. Pull up the battery cover locking lever and open
the battery cover.
2.
Pull out the battery cartridge from the mower while
sliding the button on the front of the cartridge.
3. Pull out the lock key.
4. Close the battery cover.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions:
Overload protection
When the battery is operated in a manner that causes it to
draw an abnormally high current, the tool automatically stops
and the main power lamp blinks in green. In this situation,
turn the tool off and stop the application that caused the tool
to become overloaded. Then turn the tool on to restart.
Overheat protection
When the tool or battery is overheated, the tool stops
automatically and the main power lamp lights up in red.
In this case, let the tool and battery cool before turning
the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops auto-
matically and the main power lamp blinks in red. In this case,
remove the battery from the tool and charge the battery car-
tridges or change the battery cartridges to fully charged ones.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
► Fig.24: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Control panel
The control panel has the main power switch, the mode switch-
ing button, and the indicator of remaining battery capacity.
► Fig.25: 1. Battery indicator 2. Mode switching lamp
3. Main power lamp 4. Check button 5. Mode
switching button 6. Main power switch
Main power switch
WARNING:
switch when not in use.
To turn on the machine, press the main power switch.
The main power lamp lights up in green. To turn off the
machine, press the main power switch again.
NOTE: If the main power lamp lights up in red or
blinks in red or green, refer to the instructions for tool/
battery protection system.
NOTE: This machine employs the auto power-off function.
To avoid unintentional start up, the main power switch will
automatically shut down when the switch lever is not pulled
for a certain period after the main power switch is turned on.
Mode switching button
You can switch the operating mode by pressing the mode
switching button. When the machine is turned on, the
machine starts up in the normal mode. When you press
the mode switching button, the machine shifts to the ener-
gy-saving mode and the mode switching lamp lights up
in green. In the energy-saving mode, you can decrease
the noise at mowing. When you press the mode switching
button again, the machine returns to the normal mode.
Indicating the remaining battery capacity
Press the check button to indicate the remaining battery
capacities. The battery indicators correspond to each battery.
Battery indicator status
On
15 ENGLISH
Always turn off the main power
Remaining battery
Off
50% - 100%
capacity
20% - 50%
0% - 20%