Kenwood KDC-BT375U Manual De Instrucciones página 21

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Rear panel
Microphone (supplied)
Microphone input jack
Adjust the microphone
angle
Secure using cord clamps (not
supplied) if necessary.
Depending on the operating system and the firmware version of your mobile phone, Bluetooth
features may not work with this unit.
Pair and connect a Bluetooth device for the first time
1 Press B SRC to turn on the unit.
2
Search and select the name of your receiver ("KDC-X3 "/"KDC-BT3 "/"KDC-BT3 /BT2 "/
"KDC-MP3 "/"KMR-D3 ") on the Bluetooth device.
"PAIRING" "PASS XXXXXX"
display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established automatically.
• / /
faceplate lights up.
• / /
window lights up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if you
reset the unit. To delete the paired device, see [DEVICE DELETE] on page 21.
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at any
time.
However, while in BT AUDIO source, you can connect to five Bluetooth audio devices and switch
between these five devices. (Page 22)
• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect the
device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more information.
"Device name" "PRESS" "VOLUME KNOB" appears on the
/ : "BT1" and/or "BT2" indicator on the
/ : "BT1" and/or "BT2" on the display
17
ENGLISH