Kenwood KDC-BT375U Manual De Instrucciones página 34

LEARNING STEERING REMOTE CONTROL
You can control the unit with the steering remote control keys on your
vehicle. After connection, you can configure the control keys according to
your preference.
• You can only make this configuration if your vehicle is equipped with the
electrical steering remote control.
• If the steering remote control in your car is not compatible, configuration
may not be completed and an error message may appear. (Page 35)
Make the connection
Steering remote cable (supplied)
Learning steering
remote input
terminal
Rear panel
Configure the control keys
1 Press B SRC repeatedly to enter STANDBY.
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select [SYSTEM], then press the knob.
4
Turn the volume knob to select [USER S.REMO], then press the knob.
5
Turn the volume knob to select [SET KEY], then press the knob.
A key list of 16 assignable keys appears.
• [K## NONE]: No function has been assigned.
6
Turn the volume knob to select any key from the key list to assign the
function, then press the knob.
"PRESS KEY TO ASSIGN K##" appears.
30
ENGLISH
Gray/red
Connect to your
vehicle's steering
Bright green/red
remote harness.
Contact your
KENWOOD dealer
Purple/red
for details.
(for )
7
Press and hold any control keys on your steering remote control
which you want to assign.
A list of key functions will appear on the display.
[NONE] (default)/[ATT]/[SEEK UP]/[SEEK DOWN]/[VOL UP]/[VOL DOWN]/[MODE]/
[ON HOOK]/[OFF HOOK]/[VOICE]/[ENTER]
8
Turn the volume knob to select a function to assign, then press the
knob.
The selected key function is assigned to the steering remote control key
you have selected in step 7.
The display returns to the key list as on step 5.
• [K## (Function)]: When certain function has been assigned to a key.
9
Repeat steps 6, 7 and 8 to assign other control keys.
10
Press and hold to exit.
To reassign the control keys
Press B SRC repeatedly to enter STANDBY.
1
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select [SYSTEM], then press the knob.
4
Turn the volume knob to select [USER S.REMO], then press the knob.
5
Turn the volume knob to select [RESET KEY], then press the knob.
6
Turn the volume knob to select [YES], then press the knob.
All the control keys will be reset.
Selecting [NO] will cancel the operation.
To return to the previous setting item, press
When [FACTORY RESET] is set to [YES] (page 5), it will also reset the learning
steering remote control.
.