Kenwood KDC-BT375U Manual De Instrucciones página 23

BLUETOOTH®
*1 This adjustment will not affect the volume of the other sources.
*2 Press and hold VOL to continuously increase the volume to 15.
*3 Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
[MIC GAIN] [–10] to [+10] ([–4]): The sensitivity of the microphone increases as the
number increases.
[NR LEVEL] [–5] to [+5] ([0]): Adjust the noise reduction level until the least noise is
being heard during a phone conversation.
[ECHO CANCEL] [–5] to [+5] ([0]): Adjust the echo cancellation delay time until the least
echo is being heard during a phone conversation.
Make the setting for answering a call
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [SETTINGS], then press the knob.
3 Turn the volume knob to select [AUTO ANSWER], then press the knob.
4
Turn the volume knob to select the time (in seconds) for the unit to
answer the call automatically, then press the knob.
[01] to [30], or select [OFF] to cancels. (Default: [OFF])
5
Press and hold to exit.
To return to the previous setting item, press
Make a call
You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
2
3
.
4
Default: [XX]
To return to the previous setting item, press
[CALL HISTORY]
.
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
other phone.
"(Second device name)" appears.
Turn the volume knob to select an item (see the following table), then
press the knob.
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
Press and hold to exit.
(Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "I" indicates call received, "O" indicates call made, "M" indicates call
missed.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history or call number.
2 Press the volume knob to call.
again to switch to the
.
19
ENGLISH