Kenwood KDC-BT375U Manual De Instrucciones página 43

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (×1) (B) Trim plate (×1)
(C) Mounting sleeve (×1) (D) Wiring harness (×1)
(E) Extraction key (×2) (F) Screws*
* Supplied for /
.
Basic procedure
1 Remove the key from the ignition switch, then disconnect
the terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 40.
3 Install the unit to your car.
See "Installing the unit (in-dash mounting)".
4 Connect the terminal of the car battery.
5 Press B SRC to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds.
(Page 3)
Installing the unit (in-dash mounting)
M5 × 7 mm (×4)
M5 × 6 mm (×4)
M4 × 8 mm (×1)
Installing the unit (without mounting
/
sleeve)
1 Remove the mounting sleeve and trim plate from
the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (supplied/commercially available).
Use only the specified screws. Using wrong screws
might damage the unit.
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
Removing the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the
holes on both sides of the trim plate, then pull it
out.
3 Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown on the
illustration.
Do the required wiring.
(Page 40)
Dashboard of
your car
Bend the appropriate tabs to hold the
sleeve firmly in place.
39
ENGLISH