Publicidad
Idiomas disponibles
Idiomas disponibles
TO START THE CALC CLEAN PROGRAM:
EN
1. Unplug the iron (
fig 1
)
2. Fill in the water tank
fig 2 & 3
fig 4
3. Plug the iron (
)
4. Put the iron over a sink or a basin
5. Press simultaneously the Mode button & the trigger for 20 secondes to start the Calc Clean
fig 11b
Program. (
)
The iron will start to heat up without producing steam. When arrived at the maximum
temperature, the water will start to run down
screen will blink alternatively. Once the process finished, the iron will automatically shut off.
Allow the appliance to cool down and then wipe the iron down with a damp cloth or a sponge.
IMPORTANT: this program will last 4 to 6 minutes.
PROBLEMS
Problem
Cause
The iron is plugged in, but the
No mains supply.
soleplate of the iron remains
cold.
The automatic electronic auto
off is active.
None or too little steam is
The iron is not ready to use.
being emitted.
Not enough water in the
water tank.
Anti-Drip is active
The trigger is not pressed.
The steam is blocked on
NYLON mode in order to
protect your clothes
fig 11c
. During the process, the fabrics on the LED
Solution
Check that the mains plug
is properly inserted or try
plugging the iron into a
different socket.
Move your iron.
Wait until the mode you have
selected stops blinking.
NB: on "Nylon" mode, the
steam output is low to
preserve your clothes.
Fill the water tank.
Wait for the soleplate to reach
the correct temperature.
Press the trigger to get steam
output.
Select a higher mode if
needed
8
Problem
Cause
Brown streaks come through
Residues in the steam
the holes in the soleplate and
chamber or on the soleplate.
stain the fabric.
Use of chemical
descaling agents,
perfumed or scented
additives.
Fabric fibres have
accumulated in the holes of
the soleplate and are burning.
Your linen is not rinsed
sufficiently or you have
ironed a new garment before
washing it.
Use of starch.
Pure distilled /demineralised
or softened water is being
used.
Overuse of shot of steam
Iron is leaking.
trigger.
Use of the shot of steam
trigger on NYLON, SILK or
WOOL modes.
Solution
Use the Calc Clean Program
then clean your iron.
Do not add any descaling
agents, perfumed, or
scented additives to the
water in the water tank.
Use the Calc Clean Program
and clean your iron if you
have used the above.
Clean the soleplate with a
non-metallic sponge.
Ensure linen is rinsed
thoroughly.
Always spray starch onto the
reverse side of the fabric to
be ironed and clean your iron
soleplate afterwards.
Only use untreated tap water
or mix half tap water with
half distilled/demineralised
water.
Use the Calc Clean Program
and clean your iron.
Allow more time between
each shot.
Use only the steam boost on
COTTON and LINEN modes.
9
EN
Publicidad
