Medtronic GUARDIAN LINK 3 Manual Del Usuario página 34

Troubleshooting
The following table contains troubleshooting information for the transmitter, charger, and tester. For
more information about troubleshooting, see your system user guide.
Table 1. Troubleshooting issues
Problem
You connected the
transmitter to the
charger and no lights
came on.
During charging, the
flashing green light on
the charger turns off and
you see a longer flashing
red light on the charger.
During charging, the
flashing green light on
the charger turns off and
you see a series of quick
flashing red lights on the
charger for two seconds
at a time.
During charging, a mix
of quick and long flash‐
ing red lights appear on
the charger.
Likely Cause(s)
The transmitter connec‐
tor pins are damaged or
corroded.
Your charger battery has
no power or no battery is
inserted.
Your charger battery is
low on power.
Your transmitter is low
on power.
Your charger and your
transmitter are low on
power.
Resolution
1. Check the transmitter connector pins for
damage or corrosion. For more informa‐
tion about your connector pins, see
Inspecting the transmitter connector
pins, page 21. If the pins are damaged or
corroded, contact your local representa‐
tive. It may be time to replace your trans‐
mitter.
2. If there is no damage to the connector
pins, replace the battery in the charger.
For instructions on replacing your
charger battery, see Installing a battery in
the charger, page 17.
Replace the battery in the charger. For instruc‐
tions on replacing your charger battery, see
Installing a battery in the charger, page 17.
1. Charge the transmitter continuously for
one hour. If flashing does not stop, pro‐
ceed to step 2.
2. Charge the transmitter continuously for
eight hours. If flashing does not stop, call
your local representative. It may be time
to replace your transmitter.
1. Replace the battery in the charger. For
instructions on replacing your charger
battery, see Installing a battery in the
charger, page 17.
2. Charge the transmitter continuously for
one hour. If the quick flashing red lights
do not stop, proceed to step 3.
34