D- 42327 Wuppertal; Tel.: +49(0)202; Pilot Mini Pilot Mini; Din En 1127 - WALTHER PILOT PILOT Mini Instrucciones De Servicio

Contents
Exploded Drawing
Declaration of CE-Conformity
Replacement parts
1 General Information
1.1 Identification of Model Version
1.2 Normal Use
1.3 Improper Use
2 Technical Description
3 Safety Instructions
3.1 Identification of safety instructions
3.2 General Safety Instructions
4 Assembly
5 Operation
6 Retooling and Repairs
7 Cleaning and Maintenance
8 Troubleshooting
8.1 Correction of Spray Pattern Imperfections
9 Disposal of Cleaning and Servicing Substances
10 Technical Data
2
23
24
28
28
28
29
29
30
30
30
31
32
33
34
35
36
36
37
22
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility that the
product(s) described below conform to the essential safety requirements. This declaration will be
rendered invalid if any changes are made to the equipment without prior consultation with us.
Manufacturer WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal

Tel.: +49(0)202 / 787 - 0

Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Hand-held Spray Guns PILOT Mini / -MP / -K
PILOT Mini
PILOT Mini
PILOT Mini-MP
PILOT Mini-MP
PILOT Mini-K
PILOT Mini-K
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
DIN EN ISO 12100-1
DIN EN ISO 12100-2

DIN EN 1127-1

Specification according 94 / 9 / EC
Category 2 Part marking
Authorized with the compilation of the technical file:

Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30

D- 42327 Wuppertal

Special remarks :
The named product is intended for installation in other equipment. Commissioning is prohibited
until such time as the end product has been proved to conform to the provision of the Directives
2006 / 42 / EC.
Wuppertal, the 1st of January 2010
i.V.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
Gravity-Feed Cup V 10 151 02
Material Connection V 10 152 02
Gravity-Feed Cup V 10 141 02
Material Connection V 10 142 02
Gravity-Feed Cup V 10 151 32
Material Connection V 10 152 34
DIN EN 1953
DIN EN 13463-1
Tech.File,Ref.:
II 2 G c T 6
2401
23