Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
:
Stand the unit on the tip of the
auger.
:
Disengage the auger brake by
moving the activating lever to
position B. Your earth auger is now
ready for operation.
Make sure the carburetor is
correctly adjusted – the auger must
not rotate when the engine is idling.
BT 121
To shut down the engine:
:
Push the slide control in direction of
c to $
At very low outside temperatures:
Allow engine to warm up
As soon as the engine runs:
:
Blip the throttle trigger to disengage
the starting throttle position – the
slide control moves to the normal
run position # and the engine
returns to idle speed.
:
Open throttle slightly – warm up the
engine for a short period.
If the engine does not start:
If you did not turn the choke knob to e
quickly enough after the engine began to
fire, the combustion chamber has
flooded.
:
Turn the choke knob to e
:
Set the slide control, trigger
interlock and throttle trigger to the
starting throttle position.
:
Start the engine – pull the starter
rope briskly – 10 to 20 pulls may be
necessary.
If the engine still does not start:
:
Push the slide control in direction of
c to $
English / USA
1
:
Pull off the spark plug boot (1).
:
Unscrew and dry off the spark plug.
:
Open the throttle wide.
:
Pull the starter rope several times
to clear the combustion chamber.
:
Fit the spark plug and connect the
spark plug boot – press it down
firmly.
:
Move the slide control to START.
:
Move the choke knob to e even if
the engine is cold.
:
Now start the engine.
17
Publicidad
Capítulos
Tabla de contenido
