Publicidad
Idiomas disponibles
Idiomas disponibles
Declaration of Conformity
We declare under our sole responsibility that the prod-
uct described under "Technical Data" is in conformity
with the following standards or standardization docu-
ments: EN 60745 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until Dec. 28,
2009), 2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
BTI Befestigungstechnik GmbH & Co. KG
D-74653 Ingelfingen
Jürgen Dietz
General Manager
BTI Befestigungstechnik GmbH & Co. KG
74653 Ingelfingen
Assembly
Battery Charging (see figure A)
Note: The battery is supplied partially charged. To
ensure full capacity of the battery, completely charge
the battery in the battery charger before using your
power tool for the first time.
The lithium ion battery can be charged at any time with-
out reducing its service life. Interrupting the charging
procedure does not damage the battery.
The Li-ion battery is protected against deep discharg-
ing by the "Electronic Cell Protection (ECP)". When
the battery is empty, the machine is switched off by
means of a protective circuit: The inserted tool no
longer rotates.
Do not continue to press the
WARNING
On/Off switch after the machine
has been automatically switched off. The battery
can be damaged.
To remove the battery 9 press the unlocking buttons 8
and pull out the battery downwards. Do not exert any
force.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery serv-
ice life is achieved in this manner.
Observe the notes for disposal.
2 609 932 598 • 14.11.07
i. V. Günter Hub
Purchasing Manager
Changing the Tool (see figure B)
Before any work on the machine (e. g., main-
tenance, tool change, etc.) as well as during
transport and storage, set the rotational
direction switch to the centre position. Unin-
tentional actuation of the On/Off switch can lead to
injuries.
Inserting
Pull the locking sleeve 3 toward the front and then push
the insert tool to the stop into the tool holder 2. The
insert tool is automatically locked.
Removing
Pull the locking sleeve 3 forward and remove the insert
tool.
Operation
Starting Operation
Inserting the Battery
Use only original BTI lithium ion batteries
with the voltage listed on the nameplate of
your power tool. Using other batteries can lead to
injuries and pose a fire hazard.
Note: Use of batteries not suitable for the machine can
lead to malfunctions of or cause damage to the power
tool.
Set the rotational direction switch 6 to the centre posi-
tion in order to avoid unintentional starting. Insert the
charged battery 9 into the handle so that it can be felt
to engage and faces flush against the handle.
Reversing the Rotational Direction (see figure C)
The rotational direction switch 6 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 7 actuated.
Right Rotation: For drilling and driving in screws,
push the rotational direction switch 6 left to the stop.
Left Rotation: For loosening or unscrewing screws,
push the rotational direction switch 6 right to the stop.
Setting the Torque
With the torque presetting ring 4 the required torque
setting can be preselected in 10 steps. With the cor-
rect setting, the insert tool is stopped as soon as the
screw is screwed flush into the material or when the
adjusted torque is reached. The safety clutch is deacti-
vated in the "
" position, e. g. for drilling.
Select a higher setting or switch to the "
when unscrewing screws.
" symbol
English | 25
Publicidad
