BTI PROFILINE A-UM 10,8V LI Manual Original página 33

OBJ_BUCH-891-001.book Page 33 Wednesday, January 21, 2009 3:34 PM
Declaration of Conformity
We declare under our sole responsibility that the
product described under "Technical Data" is in con-
formity with the following standards or standardization
documents: EN 60745 according to the provisions
of the directives 2004/108/EC, 98/37/EC (until
28 Dec 2009), 2006/42/EC (from 29 Dec 2009).
Technical file at:
BTI Befestigungstechnik GmbH
D-74653 Ingelfingen
Jürgen Dietz i. V. Günter Hub
General Manager Purchasing Manager
BTI Befestigungstechnik GmbH
D-74653 Ingelfingen
Ingelfingen, 19.12.2008
Assembly
Battery Charging
Note: The battery is supplied partially charged. To
ensure full capacity of the battery, completely charge
the battery in the battery charger before using your
power tool for the first time.
The lithium ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery serv-
ice life is achieved in this manner.
Removing the Battery
To remove the battery 2, press the unlocking buttons
1 and pull the battery out of the machine to the rear.
Do not exert any force.
Battery Charge-control Indication
The three green LEDs of the battery charge-control
indicator 4 indicate the charge condition of the battery
2. For safety reasons, it is only possible to check the
status of the charge condition when the machine is at
a standstill.
To indicate the charge condition, press and hold but-
ton 3 of the switched off machine.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
1 609 929 S48 • 21.1.09
Changing the Tool
Before any work on the machine itself (e.g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger of
injury when unintentionally actuating the On/Off
switch.
Wear protective gloves when changing ap-
plication tools/accessories. Contact with the
application tool/accessoriy can lead to injuries.
Selecting the Application Tool/Accessory
Capacity
≥2/3
≥1/3
<1/3
Reserve
* optional accessory
Accessory Material
HCS wood Wooden mate-
segment saw rials, plastic
blade*
BIM segment Wooden mate-
saw blade* rials, plastic, non-
ferrous metals
HCS plunge Wooden mate-
cut saw rials, plastic, gyp-
blades, wood* sum and other
soft materials
BIM plunge Metal (e.g., nails,
cut saw screws, small
blades, metal* profiles), non-
ferrous metals
BIM plunge Wood, metal,
cut saw blade, non-ferrous
wood and metals
metal*
HM-Riff seg- Grouting joints,
ment saw soft wall tiles,
blade* glass-fibre rein-
forces plastic and
HM-Riff delta
other abrasive
plate*
materials
Scraper, rigid* Carpets,
coverings
Scraper, Silicone and
flexible* other elastic
materials
Base plate Depends on
for sanding, sanding sheet
series Delta
93 mm*
English | 33