Publicidad
Idiomas disponibles
Idiomas disponibles
6 Assembling the Lawn Mower
► Press sleeve (1) into the bores in upper han‐
dlebar (2).
► Fit spring washers (3) with the convex side
facing inwards onto sleeve (1).
► Guide upper handlebar (2) into handlebar
bracket (4).
► Push bolt (5) through the bores in handlebar
bracket (4) and the sleeve in upper handle‐
bar (2).
► Place nut (6) in the notch in handlebar
bracket (4).
► Tighten bolt (5).
► Insert cable (7) in guide (8) and press into
holders (9 and 10).
► Fasten cable (7) to the handlebar using cable
clip (11).
The handlebar must not be dismantled again.
0478-121-9926-A
6.2
Folding Up and Folding the
Handlebar
6.2.1
Adjusting the Handlebar
► Switch the lawn mower off.
► Detach the extension cable connector from the
mains plug of the lawn mower.
► Place the lawn mower on a level surface.
► Hold handlebar (1).
► Press lever (2) downwards and hold.
► Move handlebar (1) into the desired position.
► Release lever (2) and ensure that the handle‐
bar fully engages again.
6.2.2
Folding the Handlebar
The handlebar can be folded for space-saving
transport or storage.
► Switch the lawn mower off.
► Detach the extension cable connector from the
mains plug of the lawn mower.
► Place the lawn mower on a level surface.
► Press and hold the lever.
► Fold down the handlebar forwards.
6.3
Assembling, Attaching and
Detaching the Grass Catcher
Box
6.3.1
Assembling the Grass Catcher Box
► Fit upper part of grass catcher box (1) onto
lower part of grass catcher box (2).
► Press pins (3) through openings (4) from the
inside.
The pins engage audibly.
English
29
Publicidad
