Kingfisher CLPYTC72BK Manual página 103

Care and Maintenance
Pyrolytic Cleaning
This function is a high temperature cleaning mode that will burn off any residues inside the cavity and
leaves ash deposits that must be wiped away with a damp cloth.
IMPORTANT! Before using this mode, ALL accessories must be removed from the
cavity including shelves, side rails, grill pans and trivets. Failure to do this will cause
Setting pyrolytic self-cleaning mode
1. Turn on the oven..
2. The door must be closed and the cavity empty before pressing the Start / Pause selector "
display will show "door" if this is still open.
3. The oven door cannot be opened during cleaning. If you wish to cancel the program, press the Power /
Cancel selector "
4. The oven will beep to indicate when cleaning is completed after two hours. Press the Power / Cancel
selector to stop the alert.
5. The door CANNOT be opened until the oven has cooled below 75°C.
6. Use a well wrung damp cloth to wipe away the ash residues before replacing the accessories.
Replacing bulbs
WARNING! Let the bulb cover cool before replacing the bulb.
NOTE:
Replace only with bulbs resistant to high temperatures with the following specification: 25W 220-240V,
T300°C G9 halogen bulb x 2.
Always switch off the power at the consumer unit first!
1. Remove the right side rail and side cover.
2. Carefully remove the cover with a flat screwdriver.
3. Replace the bulb with a new one of the same type. Handle the new bulb with a cloth to avoid risk of
premature failure.
damage to the accessories.
".
1
103
". The
2