Jacuzzi J-460 Manual De Instalación página 47

1.
A
B
3. Remove the polishing bag by reaching into the filter bucket
and gently pulling upward on the blue filter ring (empty filter bag
weekly or install a new bag every three months.)
Note: the filter (C) is located under the bag: to remove it, turn
it counterclockwise, and clean it following the instructions pro-
vided in point 6.
Replace bag, then install filter lid by rotating it clockwise until
you feel it latch in place.
DO NOT FORCE LID! FINGER TIGHT ONLY!
4. Remove the skimmer assembly (A) by gently lifting upward
from the filter bucket.
5. Remove the filter cartridge by rotating it counterclockwise to
unthread it, then remove the center cap and chemical dispenser
from the filter cartridge as shown (right).
6. Clean the filter cartridge with a garden hose and high pres-
sure nozzle. Rinse debris from the filter pleats beginning at the
top and working your way downward.
Continue, one section at a time until you have cleaned all debris
from the filter pleats. When replacing the filter cartridge, make
sure you remove the center cap and chemical dispenser for use
with the new cartridge.
Replacement filter cartridges may be purchased from
your authorized Jacuzzi dealer.
Draining and Refilling
About every 3 to 6 months, you will want to replace the water
in the spa. Frequency of water replacement depends on fre-
quency of use, care taken in maintaining water quality, etc.
You will know it is time for a change when you cannot control
sudsing and/or you can no longer see the normal sparkle to the
water, even though the key water balance measurements are all
within the proper parameters.
WARNING! Turn off power to spa before draining it. Do
not turn the power back on until your spa has been
refilled.
2.
5.
3.
4.
If it is extremely cold, and the spa is outdoors, freezing could
occur in the lines or the equipment (see the section on "Win-
terizing"). If instead it is very warm, do not leave the spa
exposed to direct sunlight.
To drain your spa, perform the following steps:
1. Turn off power to spa.
2. 2.
3. 3.
4. 4.
5. 5.
2.Locate the drain valve on the front/lower panel. Hold the
larger (rear) body to prevent it from turning, then loosen and
remove the cap.
3. Attach the hose.
4. Rotate the rear valve body 1/3 turn counterclockwise to
unlock the drain valve.
5. Pull the larger (rear) body outward to open drain.
6. After the spa drains, perform steps 2-5 in reverse order to
close the drain prior to refilling the spa.
7. After refilling,turn on power to the spa and follow the steps
listed under "Start-up instructions"
N.B.: Always fill your spa through both filter fittings.
47
C
A
B