Publicidad
Idiomas disponibles
Idiomas disponibles
Cover Guard
The transparent cover guard 17 enables the col-
lection of chips and sawdust. To achieve opti-
mum results, it must always be mounted when
working with dust extraction. When working with-
out dust extraction, do not use the dust cover 17.
Otherwise sawdust/wood chips can block the
view.
Tips
When sawing small or thin workpieces, al-
ways use a firm support or a saw table (ac-
cessory).
For tight curves it is best to use a narrow saw
blade.
When sawing metal or similar materials, apply
coolant/lubricant alongside the cutting line.
Straight Cuts in Thick Wood
– With the pushbutton for Precision Control 11,
switch on the lateral guidance feature of the
saw blade.
– Adjust the exact cutting angle with use of a
commercial angle gauge 20.
– Operate the machine with low feed only; the
orbital action and the stroke ensure sufficient
operational progress.
– Always guide the machine firmly against the
parallel guide 24 or an auxiliary guide rail and
avoid lateral pressure against the handle in or-
der to prevent the machine from jamming.
Circle Cutter/Parallel Guide
(Accessory – see figures
With the combined circle cutter/parallel guide 24,
circular cutouts or parallel cuts in materials of up
to 30 mm thickness can be made.
Maintenance and Cleaning
The guide roller 13 should occasionally be
checked for wear and lubricated with a drop of oil.
If it is worn, it must be replaced.
If the machine should happen to fail despite the
care taken in manufacture and testing, repair
should be carried out by an authorised customer
services agent for BTI power tools.
For all correspondence and spare parts orders,
always include the 6 digit order number of the
machine!
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
–
)
G
H
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine, it must
be disposed of safely.
English - 8
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and its ventilation slots clean.
In order to avoid operational malfunctions, do
not saw gypsum board from below or over-
head.
In extreme working conditions, conduc-
tive dust can accumulate in the interior
of the machine when working with
metal. The protective insulation of the
machine can be degraded. The use of a
stationary extraction system is recom-
mended in such cases as well as fre-
quently blowing out the ventilation slots
and installing a residual current de-
vice (RCD).
strain relief
live = brown
neutral = blue
To be fitted
by qualified
professional only
Publicidad
