Publicidad
Idiomas disponibles
Idiomas disponibles
Use
Switching on and off
Switching on:
♦
Push the safety lock-out
and keep it pressed.
♦
Press the ON/OFF switch
running, you can release the safety lock-out
Switching off:
♦
Release the ON/OFF switch
Setting the cutting angle
You can select the cutting angle using the cutting
angle scale
.
■
Undo the wing screw of the cutting angle pre-
selector
, set the desired cutting angle on the
cutting angle scale
wing screw
.
Setting the cutting depth
NOTE
►
Select a cutting depth of approx. 3 mm more
than the thickness of the material. This ensures
that you achieve a clean cut.
♦
Undo the locking screw
depth on the cutting depth scale
retighten the locking screw
Working with the circular saw
1. Switch on the appliance – as described in
"Switching on and off" – and then place it with
the front edge of the base plate
rial.
2. Align the machine using the rip fence
using a marked line.
3. Hold the machine in both hands using the han-
dles and saw by exerting an even pressure.
Switching the laser on and off
Switching on:
♦
Press the ON/OFF switch laser
Switching off:
♦
Press the ON/OFF switch laser
PHKSA 20-Li A1
to the left or right
. Once the saw is
.
and then retighten the
, set the desired cutting
and then
.
on the mate-
or by
.
.
Tips and tricks
■
Avoid damaging the cutting edge of sensitive
materials, e.g. coated chip boards or doors, by
sticking masking tape along the cutting line. This
also makes it easier to mark a line on the tape
than on a shiny surface. An even more effective
method of protecting the cutting edges is to
.
clamp a thin piece of wood along the cutting
line (this wood is also sawn).
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The cordless hand-held circular saw is mainte-
nance-free.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the appliance.
■
Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■
The blade guard must always move freely and
close automatically. Therefore, keep the area
around the blade guard clean at all times. Re-
move dust and chips by blowing them out with
compressed air or with a brush.
■
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
│
GB
27
■
Publicidad
