Chamberlain 45ACT Instrucciones De Instalación página 3

Reemplazo de la tarjeta lógica del receptor

Ocultar thumbs

página de 12

/ 12
Marcadores

Idiomas disponibles

Adjustment

Program the travel

Without a properly installed safety reversal

system, persons (particularly small children)

could be SERIOUSLY INJURED or KILLED by

a closing garage door.

• Incorrect adjustment of garage door travel

limits will interfere with proper operation

of safety reversal system.

• After ANY adjustments are made, the

safety reversal system MUST be tested.

Door MUST reverse on contact with 1-1/2"

(3.8 cm) high object (or 2x4 laid ﬂ at) on

ﬂ oor.

1.4 Press and hold the DOWN Button

until the door is in the desired DOWN

position.

NOTE: The UP and DOWN Buttons can be used to move

the door up and down as needed.

* If the garage door opener lights are ﬂ ashing 5 times during the steps for Program the Travel, the programming has timed out. If the garage door opener lights are ﬂ ashing 10 times during the steps for

Program the Travel, the safety reversing sensors are misaligned or obstructed. When the sensors are aligned and unobstructed, cycle the door through a complete up and down cycle using the remote

control or the UP and DOWN buttons. Programming is complete. If you are unable to operate the door up and down, repeat the steps for Programming the Travel.

1.1 Press and hold the Adjustment Button

until the UP Button begins to ﬂ ash and/

or a beep is heard.

1.5 Once the door is in the desired

DOWN position press and release the

Adjustment Button. The garage door

opener lights will ﬂ ash twice and the UP

Button will begin to ﬂ ash.

1.2 Press and hold the UP Button until the

door is in the desired UP position.

NOTE: The UP and DOWN Buttons can be used to move

the door up and down as needed.