Publicidad
Idiomas disponibles
Idiomas disponibles
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
10
TROUBLESHOOTING
Problem
Possible cause
The handle is not
The bolts are not
in position.
engaged correctly.
The machine does
The battery ca-
not start.
pacity is low.
The start handle is
defective.
The battery key is
not put in.
The machine cuts
The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does
Wet grass clip-
not mulch correct-
pings attach to the
ly.
deck.
The mulch plug is
missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
English
Problem
There is a high vi-
bration in the ma-
chine.
Solution
Adjust the height
of the handle and
make sure that the
bolts and nuts are
aligned correctly.
Charge the battery
The machine stops
pack.
during mowing.
Replace the start
handle.
Put in the battery
key.
ing area.
Move the wheels
to a higher posi-
tion.
* If you cannot find the solution to these problems, go to the
Wait until the
service center.
grass dries before
mowing.
11
Install the mulch
plug.
Voltage
Increase the blade
Battery model
height.
Charger model
Empty the grass
clippings from the
No load speed
grass catcher.
Height adjust-
ments
Self-propelled
speed
Functions
Weight (without
battery pack)
Double-insulated
construction
13
Possible cause
The blade is un-
balanced and
worn.
The motor shaft is
bent.
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
TECHNICAL DATA
80 V
BAB723/GBA80200/GBA80400 and
other BAB series
CAB812/GCH8040 and other CAB
series
4000 RPM / 4500 RPM (Turbo)
1 3/8 - 4 1/16" (3.5 - 10.2 cm)
1.9-4.9 fps (0.6-1.5 m/s)
2-in-1 Mulch & Rear Bag
69.4 lbs (31.5 kg)
EN
Solution
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
Increase the blade
height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.
Publicidad
