Publicidad
Idiomas disponibles
Idiomas disponibles
7.2
PLACE THE MOWER UPRIGHT IN
VERTICAL POSITION
G
5
1. Place the mower upright in vertical position.
2. Remove the packing material from the cable.
3. Remove the rubber edge guard (G) from the upper
handle.
4. Insert the upper handle (4) into the lower handle (5).
5. Put the bolts (13) through the holes and tighten with the
nuts (14), using a Philips head screwdriver (not included).
WARNING
Do not damage the cable while installing the upper handle.
7.3
UNFOLD AND ADJUST THE
HANDLES
1. Pull up on the handle holes (26) to release the handles.
4
13
14
5
26
12
English
2. Fold the handles up until the handle pins (12) lock into
position.
Make sure that the two handle pins are in the same position.
7.4
INSTALL THE GRASS CATCHER
1. Remove the mulch plug.
2. Open the rear discharge door (6) and hold it.
3. Hold the the grass catcher by its handle and engage the
hooks on the slots (15).
4. Close the rear discharge door.
7.5
INSTALL THE MULCH PLUG
1. Remove the grass catcher.
2. Open the rear discharge door (6) and hold it.
3. Hold the mulch plug (10) by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
7.6
SET THE CUTTING HEIGHT
The machine can be set to different cutting heights.
9
NOTE
15
6
10
EN
6
Publicidad
