Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
SAVE THESE INSTRUCTIONS: This manual contains important
instructions that should be followed during installation,
operation, and maintenance of the product.
SAFETY SYMBOLS
This is the safety alert symbol. When you see this symbol
on your pump or in this manual, look for one of the following
signal words and be alert to the potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The word NOTE indicates special instructions that are
important but not related to hazards.
CALIFORNIA PROPOSITION 65 WARNING:
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
GENERAL SAFETY
Carefully read and follow all safety instructions in this
manual and on the unit itself. Failure to comply with the
safety instructions could result in personal injury and/or
property damage!
Know the pump application, limitations, and potential
hazards. Follow all applicable local and state codes and
regulations.
Do not run the pump dry. Dry running can overheat the
pump, (causing burns to anyone handling it) and will void
the warranty.
Vent sewage or septic tank according to local codes.
Do not install the basin or pump in any location classified
as hazardous by the United States National Electrical
Code (NEC), or by the Canadian Electrical Code (CEC),
where applicable.
WARNING
Risk of electrical shock.
Can burn or kill.
Do not lift pump by power cord.
MY538-R (08-20-20)
All manuals and user guides at all-guidesbox.com
ELECTRICAL SAFETY
When installing, operating, or servicing this pump, follow the
safety instructions listed below.
CORD LIFT WARNING
Keep safety labels in good condition, replacing any
missing or damaged labels.
Do not touch an operating motor. Modern motors can operate
at high temperatures. Do not handle pump or pump motor
with wet hands or when standing on wet or damp surface, or in
water.
Personal Safety:
a. Wear safety glasses at all times when working with
pumps.
b. Keep work area clean, uncluttered and properly
lighted – replace all unused tools and equipment.
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks, master
switches, and by removing starter keys.
Hazardous voltage. Can shock, burn, or kill.
Disconnect power before servicing. Disconnect power to
outlet box before unplugging.
Take extreme care when changing fuses. Do not stand in
water or put your finger in the fuse socket.
DO NOT allow the plug on the end of the electrical cord to
be submerged.
Do not modify the cord and plug. When using the cord
and plug, plug into a grounded outlet only. When wiring to
a system control, connect the pump ground lead to the
system ground.
All wiring should be performed by a qualified electrician.
Make certain power source conforms to requirements of your
equipment.
Do not lift pump by cord (see below).
1.
Attempting to lift or support pump by power
cord can damage cord and cord connections.
2.
Cord may pull apart, exposing bare wires with
possibility of fire or electrical shock.
3.
Lifting or supporting pump by power cord will
void warranty.
4.
Use lifting ring or handle on top of pump for all
lifting/lowering of pump. Disconnect power to
pump before doing any work on it or attempting
to remove.
3
Publicidad
