Snap-On EEWB332B Manual De Operador página 34

1
2
3
4
Figure 32
Figure 34
Figure 37
A
Figure 38
34
The result is recalculated.
Reading
Option 3:
•
The imbalance on the wheel is shown on the readout.
•
Reading
Readjust tire on the rim (the right display bars light up
permanently).
Option 1: Readjust the tire on the rim
5
(normal program)
•
•
•
•
•
Reading Un.8 appears
•
If weight minimization was carried out correctly
(according to the program cycle), the machine
automatically returns to the type of weight positioning
previously selected and indicates the residual dynamic
imbalance on the wheel.
•
Both weight minimization and balancing are
Message E9
Message E9 means that at least one error occurred
during the minimization cycle. Press the STOP key (5) to
exit the minimization program and repeat minimization
if necessary.
Option 2: Do not readjust the tire on the rim
•
B
The imbalance on the wheel is shown on the readout.
•
Reading H0
The optimum minimization condition has been achieved
and cannot be improved.
•
Figure 39
EEWB332B
Un.7 - II or H0 appears
Press the STOP key (5)
program and return to the balancing program
Balance the wheel according to the readings.
Un.7 - II (Fig. 37)
Readjust the wheel according to the right direction
indicator and make a double mark on the right side
of the tire exactly perpendicular to and above the
main shaft (Fig. 38).
Remove the wheel from the machine.
Readjust the tire on the rim until the double mark
coincides with the valve (Fig.
Clamp the wheel on the balancer and readjust it so
that the valve is exactly perpendicular to and above
the main shaft.
Press the ENTER key (1) to acquire the valve
position.
(Fig.
Spin the wheel (START) (check run).
Balance the wheel according to the readings.
accomplished.
Press the STOP key (5) to exit the minimization
program and return to the balancing program
Balance the wheel according to the readings.
Press the STOP key (5) to return to the balancing
program and continue according to the readings.
to exit the minimization
39).
34).