Publicidad
Idiomas disponibles
Idiomas disponibles
BUMPER BAR HANDLE COVER
2
To attach: Before attaching the bumper bar to the stroller,
wrap the handle cover around the bar (Fig. 2a).
BUMPER BAR
3
WARNING:
or carry seat with child inside. The bumper bar is not a
carrying handle.
WARNING-FALL HAZARD:
bar is not designed to support a car seat, stroller may
become unstable.
Attach the bumper bar by lining up anchors with the slots on the seat.
Push until it locks into place (Fig. 3a).
securely attached before using this product.
To detach the bumper bar, press the release button on the bottom of
the bar on each side, and pull bar out of the anchors (Fig. 3b).
Fig. 3a
5
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 2a
Do not use bumper bar to lift
Bumper
NOTE: The bumper bar must be
Fig. 3b
TO ADJUST SEAT
4
WARNING:
used only for a child that is at least 6 months old.
Toddler Seat Mode: The seat can be
adjusted into an upright, reclined position.
Push the center button on both sides of the
stroller adapter to rotate the seat (Fig. 4a).
Rotate the seat into the desired position
until it clicks into place (Fig. 4b). The seat
can face in either direction, frontward or
backward.
Buckle the strap located underneath the
seat (Fig. 4c). To tighten the strap, use the
hook and loop method through the clip.
Pull the strap firmly and attach.
To adjust the recline seat strap, squeeze
the adjuster while pulling downwards or
upwards (Fig. 4d).
Note: There are 6 positions for the leg-rest.
Press on both sides to unlock, adjust to
desired position and release the buttons to
lock into position (Fig. 14e).
1
2
Fig. 4c
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
The upright position should be
Fig. 4a
Fig. 4b
Fig. 4d
button
Fig. 14e
6
Publicidad
