Kärcher HD 6/15 C Manual Del Usuario página 16

Oil level control
Read the oil level indicator with the
device stopped. The oil level must be
above both needles.
Turn on the oil tank fan
Remove the machine cover mounting
screw and remove the cover.
Cut off the tip of the oil
container cover.
Secure the machine's cover.
Assembling the accessories
Mount the nozzle on the spray lance
(the mark on the support ring must be
on top).
Connect the spray lance with the
manual spray gun.
Release the push bar lock.
Adjust the push bar to the
desired temperature.
Tighten the push bar lock.
Screw the high-pressure hose onto the
high-pressure connection.
Start-up
Electrical connection
Danger
Risk of injury from electrical discharge.
Connect the device to AC power only.
The device may only be connected to an
electrical connection that has been
installed by an electrician in accordance
with IEC 60364-1.
The power supply must match the voltage
indicated on the machine's nameplate.
Minimum fuse protection of the power
outlet (see technical data).
The maximum permissible mains
impedance at the electrical connection
point (see technical data) must not be
exceeded. In case of confusion about the
existing mains impedance at your
connection point, contact your power
supply company. It is crucial for the device
to be connected with a plug to the mains.
Establishing a non-separable connection
to the power grid is prohibited. The plug is
used to disconnect from the mains. Before
each start-up, check the power cord and
mains plug for damage. If the power cord
is damaged, it must be replaced
immediately by a qualified electrician from
authorized customer service.
The plug and coupling of the extension
cord used must be waterproof.
Use an extension cord with sufficient
cross-section (see "Technical Data") and
wind from the front of the cord drum.
Unsuitable extension cords can be
dangerous. For outdoor use, use only
extension cords that are expressly
approved for this purpose, properly
marked and with sufficient cross-section:
Connection values: see
nameplate/technical data.
Water connection
Water inlet connection
Warning
Follow the water
supplycompany's regulations.
In accordance with current
regulations, use of the machine
is prohibited without a system
separator in the drinking water network.
A suitable system separator from
KÄRCHER should be used or,
alternatively, a system separator
complying with
EN 12729 type BA.
The water that has passed through a
system separator will be classified
as non-potable.
Attention
Always connect the system separator
to the water supply, never directly to
the device!
14