Weidmuller THM MultiMark Plus Manual Del Usuario página 57

6.4 Cleaning the label sensor
Label sensor can be damaged!
Do not use sharp or hard objects or solvents to clean the label sensor.
The label sensor can become dirtied by paper dust. This can adversely affect label detection.
1
2
3
Figure 18 Cleaning the label sensor
f Remove labels and transfer ribbon from the printer.
f Loosen screw (2).
f Hold pressed the button (1) and slowly pull label sensor outward via the tab (3). Ensure that the label sen-
sor cable is not tensioned by this.
f Clean label sensor the slots (4) with brush or cotton swab soaked in pure alcohol.
f Push label sensor back via tab (3) and set it (→ „4.1.3 Setting the Label Sensor" on page 49).
f Reload labels and transfer ribbon.
2599440000/00/04.2019
ATTENTION!
4
Cleaning
57