Publicidad
Idiomas disponibles
Idiomas disponibles
INSTAllING CAMERA
Before installation
Before installing your camera, you have to read the following cautions:
You have to check whether the location (ceiling or wall) can bear five times the weight of your camera.
Don't let the cable to be caught in improper place or the electric line cover to be damaged. Otherwise
it may cause a breakdown or fire. You can use wall mount adaptor (SADT-102WM), and pole mount
adaptor (SADT-100PM) for installing the camera on the wall or pipeline.
When installing your camera, don't allow any person to approach the installation site. If you have any
valuable things under the place, move them away.
About the installation holes
A: Use these holes when directly installing
your camera on the ceiling or wall.
While those are not used, fill in the holes
using the screw machine (M5 X L6.) for
waterproofing.
B: Use four holes when directly installing
your camera on the junction box
You can use the 4 1/8 diameter round
type junction box for assembly.
(The junction box, gasket, and cover are
separately purchased items.)
C: Use these holes when installing the wall
mount adapter (SADT-102WM)
While those are not used, fill in the holes
using the screw machine (M5 X L6.) for
waterproofing.
The holes that are not used should be tightly sealed up using the screws provided for
waterproofing. When the screws don't have rubber rings inside or are not closely attached, note
that it can cause waterproofing problem. For attaching screws, see page 19 "Disassembling/
assembling the Main body from the Case."
14_
Installation and Connection
A
B
C
Publicidad
