Publicidad
Idiomas disponibles
Idiomas disponibles
<E-mail(SMTP) Transfer> : You can transfer an alarm image through Email. This function supports
- <SMTP Server Address>: Enter the IP address of an SMTP server to be used to send an Email.
- <User ID>: Enter a user account ID to connect to connect the SMTP server.
- <Password>: Enter a user account password to the SMTP server.
- <E-mail Sender>: Enter the address of the Email sender. If the sender address is incorrect, the Email
from the sender may be classified into SPAM mail by the SMTP server and may
not be sent.
- <E-mail Receiver>: Enter the address of the Email recipient.
- <Title>: Enter the title of the Email.
- <Message>: Enter the contents of the Email. An alarm image is attached to the Email as an attached
file.
To test Email transmission
Click the [Test] button.
Connect to the configured SMTP server
and conduct image transmission test
automatically.
When the SMTP server connection and
transmission tests are complete,
the <Verified> message will be displayed.
If the test fails, an error message appears.
In this case, check the SMTP server status
and the configured settings once again.
To setup the record
1
Click <EVENT> <RECORD SETUP>.
The RECORD SETUP window appears.
2
To complete the setting,
click the [Apply] button.
The settings are saved.
<SD Card>: Enables you to verify data saved on the SDHC memory card and format the
memory card itself. It is possible to set to automatically delete movie clips
recorded before a certain period of time (e.g. 1 week, 1 month, or 1 year).
<Options>: Determine whether or not you wish to receive Email notification of insufficient
capacity warnings.
SMTP Email server only. When the initial SMTP server setting and
connection are not verified, the <Not verified> message appears.
Example) smtp.hotmail.com
_69
Setting Up
Publicidad
