Installing on a pipe
Before installation, you have to be familiar with the cautions on page 14 and fill in the holes
that are not used for installation. The holes that are not used should be tightly sealed up using
the screws provided for waterproofing. (Refer to page 14)
To install your camera bottom on a pipe
1
After connecting the power and video cables, throw them
inside the pipeline and screw the male thread pipe into the
female pipe thread in your camera tightly to fix the Main
body. (In this case, be sure to tape with Teflon tape before
assembly for waterproofing. Be careful for the wiring cable
not to be stuck in the connection area.)
2
Adjust the angle of the camera
in search of a better view.
1. Separate the Dome cover using the
L-Wrench provided.
(To make loose the screws, rotate
counterclockwise.)
2. Adjust the lens direction. For more
information, see page 20 "Adjusting
the camera direction."
3
Attach the Dome cover.
(Screw the connection bolts
tightly using the L-Wrench for
waterproofing.))
To change the SAMSUNG logo
position, move the location of the
connection rubber band as show
below and rotate for assembly.
(The rotation limit is 180 degree.)
Installation and Connection
_15