[STEP 2] Checking if the IP router is connected to the xdSl/Cable
modem properly
Select <Status> from the Settings menu of the IP Router
If it is properly connected, <IP Address>, <Subnet Mask> and <Gateway> provided by
your ISP are displayed. Please remember these values because they are required so that
an external remote computer of the IP router connects to the camera. However, note that
certain ISPs change the settings of <IP Address>, <Subnet Mask>and <Gateway>on a
regular basis
If the IP router is not properly connected, press the [Connect] button to try to reconnect
or check if the settings of the IP router are correct.
[STEP 3] Setting the IP address
Refer to "Static IP Setting" on page 36 or "Dynamic IP Setting" on page 40.
[STEP 4] Connecting a local PC in the IP router to the camera
1
Run the IP Installer on your local PC and
search for the camera.
2
If found, double-click the camera to
start the Internet browser and try to
connect to the camera. Alternately,
launch the Internet browser manually
and enter the IP address of the camera
found in the address bar to connect to it.
ex) http://192.168.1.2
28_
Network Connection & Setup