Descargar Imprimir esta página

cecotec BOLERO 10500 INVERTER A Manual De Instrucciones página 61

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
B. Factory state
-
Lock nuts on the bottom of the washing machine
-
Levelling feet fitted to the lock nuts
Please note
The levelling feet do not come fully fixed for easier installation, so be sure to fix all four before
levelling the washing machine.
When positioning the washing machine, you should check if the levelling feet are fully
1.
fixed; if not, fix them. The lock nuts must be firmly locked to the bottom of the appliance
and the levelling feet securely locked into the lock nuts. Fig. 7
2.
Once the washing machine is installed, press on the opposite corners of the top with both
hands in succession and shake the washing machine vertically downwards to check if the
levelling feet are firmly fixed and that the washing machine does not wobble. Fig. 8
If the washing machine wobbles, loosen the lock nut in the direction shown in Figure 9
3.
with the spanner provided until the machine is level and no longer wobbles. Fig. 9
Finally, use the spanner to fix the lock nut to the bottom of the washing machine (you can
4.
also fix the levelling feet lightly by hand to prevent them from moving). Make sure the
levelling feet do not move. Fig. 10
Warning
1.
The washing machine must be perfectly level and stabilised when all four feet are firmly
on the floor.
2.
Incorrect levelling adjustment may cause loud noises, vibrations of the washing machine,
shifting of the washing machine, and other abnormal occurrences.
3.
The air vent is located at the bottom of the washing machine (to avoid obstructions).
Install the washing machine on a solid, smooth, non-slip floor. Do not place the washing
machine on a soft blanket or wooden floor or on top of furniture, as this may cause
unnecessary injury.
4. OPERATION
Installing the washing machine
Connecting the inlet hose. Fig. 11
Connect the inlet hose to the tap and fix it by turning it counterclockwise.
1.
2.
Connect the other end of the inlet hose to the inlet valve on the back of the washing
machine and secure it firmly clockwise.
BOLE R O D R E S S CO D E 1 0 5 0 0 I N V ERTER A
BOL E RO D R ES S COD E 1 0 5 0 0 I N V ERTER S TE EL A
ENGLISH
61

Publicidad

loading

Este manual también es adecuado para:

Bolero 10500 inverter steel a