cecotec BOLERO 10500 INVERTER A Manual De Instrucciones página 72

ENGLISH
remove dirt from the surface. Make sure that the surface of the washing machine remains
dry at all times. Do not scratch the washing machine with sharp objects.
2. The surface can be cleaned with diluted non-abrasive, neutral detergents if necessary.
Cleaning the drain outlet
Open the drain-outlet cover as shown in Figure 14. You can open it with the help of a
1.
non-sharp, non-cutting object.
Unscrew the plug and remove any foreign material or objects from the drain outlet. Be
2.
careful with possible water that may come out during the process. Fig. 15
Refit the plug and close the cover. Fig. 16
3.
Cleaning the water inlet valve filter
The inlet filter must be cleaned if no or insufficient water enters when the tap is opened.
Lower the water pressure:
1.
a. Close the tap.
b. Select any programme except Spin Only.
c. Press the Start/Pause button and keep the programme running for about 40 seconds.
d. Disconnect the plug.
2. Disconnect the inlet hose from the tap. Fig. 17
Gently pull out the filter using a pair of needle-nosed pliers. Use extreme caution not to
3.
force the filter to avoid damaging it. Fig. 18
Wash the filter with water and remove any accumulated dirt.
4.
5. Place the filter back in its original position.
Reconnect the inlet hose. Fig. 19
6.
Cleaning the detergent drawer
1. Open the detergent drawer (lift it up slowly) and remove the siphon by lifting it up as
shown in Figure 20.
2. Wash the detergent drawer and the siphon with tap water or clean them with a brush.
Refit the detergent drawer and the siphon.
3.
- It's possible for some detergent to get into the drum when removing the detergent drawer.
This is normal.
- To avoid spillage, make sure that no water, detergent, or softener is left in the detergent
drawer before removing it.
Defrosting
Do not expose the washing machine to temperatures below 0°C, as this may affect its operation
and the lifespan of its parts. Should you notice frozen parts, follow the below procedure:
1. Turn off the washing machine and unplug the power cord.
Pour hot water over the tap to loosen the water inlet hose.
2.
3. Disconnect the water inlet hose and immerse it in hot water.
B OL E RO D RE SS CO D E 10 5 0 0 I N V E RTE R A
72
B OL E RO D RE SS CO D E 10 5 0 0 I N V E RTE R STEEL A