Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing Your Home
EN
Tidy up items such as power cords, cloths, slippers, and toys to
improve the efficiency of the robot.
Open the door of the room to be cleaned, and put the furniture in
its proper place to leave more space.
Note:
· When operating the robot for the first time, follow it around while cleaning to remove any potential obstacles in time.
· To prevent the robot from not recognizing areas that need to be cleaned, do not stand in front of the robot, threshold, hallway, or narrow places.
8
Before cleaning, place a physical barrier at the edge of the stairs
and sofa to ensure the secure and smooth operations of the robot.
With the AI visual sensor, the robot can better recognize and
avoid obstacles such as power cords, shoes, and socks, to get the
most out of the AI visual sensor, make sure that all areas to be
cleaned are well-lit.
Before Use
1. Remove the protective strips
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
3. Set up the charging dock
Stick the double-sided tape at the bottom of the charging dock,
then place the dock on the level ground against the wall and
connect it to a power outlet.
＞ 0.5 m
＞ 0.5 m
＞ 1.5 m
Note:
· Keep the immediate area 1.5m in front of the charger and 0.5m to both sides of the
charging dock clear of objects.
· To ensure you can connect to the robot with your phone well, make sure the robot and
charging dock are within Wi-Fi range.
· Do not place the charging dock in an area with direct sunlight or where other objects
might block the signal, as this may hinder the robot from returning to the charging dock.
· Use of the double-sided tape depends on your need.
· Please clean the floor area where the charging dock will be placed with a dry rag.
· If necessary, remove the double-sided tape slowly to reduce adhesive residue.
4. Place the robot onto the charging dock to charge
Battery Level Indicator
• White: Battery level is more than 15%
• Orange: Battery level is less than 15%
Note:
· Fully charging is recommended before first-time use.
· Do not install the mopping module while charging. Be extra careful with the wet mop
as it can damage the floor.
EN
9
Publicidad
