Eureka ATOM Instrucciones De Manejo página 26

7.1
APPLIANCE
SWITCH-ON
When switching the appliance
ured in the mode set by the
factory and anyway, in the fol-
lowing uses, it will maintain the
last mode previous to switch
off.
When switching the ap-
pliance on, this screen is
shown for some seconds.
Then the display shows the
working screen.
APPLIANCE PROGRAMMING
A A B B
C C D D
7
T1 T1 T2 T2 T4 T4 T5 T5
7.2
DOSE DISPENSING
AND SETTING
(DISPLAY)
-
• Select a dose by pressing
(T2), which will light up.
Press the grinding start
key (7) to dispense cof-
fee and activate the timer
up to zero; the cup (C) on
the display fills during dis-
pensing.
• Once dispensing is com-
pleted, the time returns to
set value for a new grind-
ing.
• The single dose counter
(A) is increased of 1.
• Select the two doses by
pressing (T4), which will
light up. Press the grinding
start key (7) to dispense
coffee and activate the
timer up to zero; the cup
(D) on the display fills dur-
ATO M
S P ECI A L ED ITI O N
ing dispensing.
• Once dispensing is com-
pleted, the time returns to
set value for a new grind-
ing.
• The double dose counter
(B) is increased of 1.
• By pressing the increasing
key (T5) and decreasing
one (T1) the dispensing
time of the properly se-
lected dose is increased
or decreased.
The automatic dispensing can
be stopped before the grind-
ing time has elapsed. During
dispensing, press the grinding
Press the new grinding start
key (7) again to restart dis-
pensing for the remaining
time;
Press the key of the selected
pensing. The grinding time re-
turns to the value set.
L I B R E T TO I ST R UZ I O N I
U S E R H A N D B O O K
M A N U EL D 'I N ST R U CTI O N S
G E B R AU CH SA N W EI SU N G EN
I N ST R U CCI O N ES D E M A N E J O
-
-
26