Daikin BAEF125AWB Manual De Instalación página 17

4. Bundling the power supply wires (black and white) and the earth wire (green or yellow), secure them to
fixing part A inside the indoor unit control box and fixing part B on the bell-mouth using clamps (2).
(Refer to Figure 19.) However, if using a harness sold separately, secure them together to fixing part B.
5. Secure relay harnesses (3) and the signal wire (grey) to fixing part C inside the indoor unit control box
using clamps (2). (Refer to Figure 20.)
Clamp (2)
(Accessory)
6. After passing the lead wires of the swing motor through the through-hole for lead wires (Refer to Figure 21),
pass the lead wire of the swing motor through glass tube (large) (4).
Thereafter, connect relay harness (large) (3) to the lead wire of the swing motor. (Refer to Figure 22.)
7. Put the connected connector inside the glass tube and secure by tightening both ends of the glass tube
with clamps (2). (Refer to Figure 22.)
8. Push the lead wires of the swing motor into the position shown in Figure 21 and secure them with
a clamp plate. (Refer to Figure 21.)
English
01_EN_3P701968-3.indd 16 01_EN_3P701968-3.indd 16
Power supply and earth wires
Fixing part B
Indoor unit control box
Figure 20
Clamp plate
Through-hole
for lead wires
Figure 21
Power supply
and earth wires
Fixing part A
Clamp (2)
(Accessory)
Figure 19
Fixing part C
Clamp (2)
(Accessory)
Connected lead wires
Push them in as far
as possible.
Lead wire of the swing motor
16
12/05/2023 15:12:33 12/05/2023 15:12:33