Hitachi SPX-WKT2 Manual Del Usuario página 20

5.10 OPERATION LOCK ("Functions" menu)
This function is used to lock the operation mode from the
remote controller.
The remote controller can be set to fix the "Heating" mode
(including "Fan"), "Cooling" mode and "Dehumidifying" mode
(including "Fan") operations.
1 When unit is OFF, select "Lock" from the menu and press
"OK". The screen of "Mode Lock" selection will be displayed.
The menu of normal screen
When "filter sign" is turned on
2 By repeatedly pressing ""or "", the indication is changed
in order of "No Setting" <---> "COOL" <---> "HEAT"
Select the function target and press "OK".
The confirmation screen will be displayed.
When this function is not used
When "Cooling" mode lock is selected
When "Heating" mode lock is selected
3 Select "Yes" by pressing ""or "" and press "OK".
The operation lock will be set and "
the screen of normal mode.
NOTE
• This function will not activate if "Timer" reservations activate.
"Timer" reservations shall be deactivated first.
Then, this function can be activated.
• If power failure happens, the lock setting will disappear. You
may need to set again.
• For multi connection, unit and mode which is set to lock
"Heating" and switched on first shall have higher priority.
Other units which are chosen to operate at different modes
shall be in "Standby" until either the first unit operation is
switched off or the model is selected to be same as the first
unit.
- 20 -
" will be indicated on
ex. Select "Cooling" mode lock