Hitachi SPX-WKT2 Manual Del Usuario página 5

3. PREPARATION BEFORE OPERATION
3.1 ADJUSTING DATE/TIME
This function is used to adjust the date and time.
Periodic time setting is recommended. (Clock accuracy:
difference within +/-5 seconds by month).
As for this remote controller, the clock can work up to 72
hours when power failure occurs.
Reset the date and time if the remote controller remains
without power supply for longer than 72 hours or main
power is OFF for long time.
1 Press " " (menu).
Select "Remocon Settings" from the menu and press "OK".
2 Select "Adjusting Date/Time" from the menu and press
"OK".
3 Press "" or "" and select "yy/mm/dd/hh/mm".
4 Press "" or "" to change the setting. Press or keep
"" or "" to adjust numbers.
3.2 LANGUAGE SETTING
This function is used to change the displayed language.
1 Select "Language" from the menu and press "OK".
2 Press "" or "" to select the language and press "OK".
The confirmation screen will be displayed.
5 After the setting is completed, press "OK" and the
confirmation screen will be displayed.
6 Select "Yes" by pressing "" or "" and press "OK".
The setting will be confirmed and the screen will return to
the normal mode.
3 Select "Yes" by pressing "" or "" and press "OK".
The setting will be confirmed and the screen will return to
the normal mode.
NOTE
• If displayed language is changed, "Contact information" will
be deleted.
• Refer to "Contact information" section of Installation manual.
- 5 -