Hach SC4500 Instrucciones Para El Usuario página 13

Table 2 pH and ORP sensor wiring – sensors with fixed cables
Terminal
8-pin (J5) 1
2
3
4
5
6
7
8
2-pin (J4) 1
2
Sensor shield wires – Connect all sensor
ground/shield wires to the controller enclosure
grounding screws.
Table 3 pH and ORP sensor wiring – sensors with removable cables
Terminal
8-pin (J5) 1
2
3
4
5
6
7
8
2-pin (J4) 1
2
1
If the combination sensor does not have a blue wire (or yellow wire for 6-plug sensors) for
solution ground, install a jumper wire between pins 1 and 2 on the 8-pin (J5) connector.
2
If an electrode with a ground solution is used, connect the wire to pin 2 on J5 and do not make
a jumper. For the VP-Plug, use the blue wire.
Description
Differential
sensor
Reference Green
Ground solution Clear
–V supply White
— —
— —
Temp Yellow
Temp/Circuit low Black
— —
Active Red
— —
Clear with a
black band
Description
Reference
Ground solution
–V supply
—
—
Temp
Temp/–Circuit low
—
Active
—
Sensor with an attached cable
Combination
sensor
Metal braid
Blue
(or yellow for 6-plug
1
sensors)
—
—
—
Red
(or green for 6-plug
sensors)
White
—
Clear
—
Cable type (connector)
Top68 (with temp)
Black shield
Jumper 1–2 on J5 Jumper 1–2 on J5
—
—
—
(Red)
(White)
—
Black signal Transparent
—
8350 8350.3/4/5
Black
(coax shield) (coax shield)
Jumper 1–2 on J5 Jumper 1–2 on J5
—
—
—
Red
White
—
Transparent Transparent
(coax core) (coax core)
—
—
SMEK VP-Plug
Black Red
Jumper 1–2 on J5
— —
— —
— —
Green Green
White White
— —
Black/transparent
— —
English 13
Black
—
—
—
Red
White
—
Blue
2