Sanus VisionMount SF203 Manual De Instrucciones página 10

2
Wall Mounting - Solid Concrete
and Concrete Block
2-1
Level wall plate [01] and mark hole locations
2-2
Drill pilot holes as illustrated
2-3
Insert anchors [07]
2-4
Tighten lag bolts [06] only until they are pulled fi rmly against the wall plate [01]
[06]
10
All manuals and user guides at all-guides.com
CAUTION:
damage!
Mount the wall plate [01] directly onto the concrete surface.
Minimum solid concrete thickness: 8 in.
Minimum concrete block size: 8 x 8 x 16 in.
NOTE: The SF213 is shown.
[01]
CAUTION:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a
10 mm (3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
CAUTION:
[07]
sure the anchors [07] are seated fl ush with the concrete surface.
CAUTION:
the lag bolt. To avoid potential injuries or property damage: DO NOT
over-tighten the lag bolts [06].
[07]
Fit lag bolt covers [14] over lag bolts [06].
NOTE: The SF213 is shown.
[01]
For assitance in determining wall plate location, see Height Finder at sanus.com.
Avoid potential personal injuries and property
To avoid potential injuries or property damage:
75 mm
(3 in.)
To avoid potential injuries or property damage: Be
Improper use could reduce the holding power of
[14] [06]
13 mm
10 mm
(1/2 in.)
(3/8 in.)
6901-002128 <00>