Publicidad
Idiomas disponibles
Idiomas disponibles
Thermostat Installation
1.
Use Cozy thermostat 78355 or any 24
volt thermostat.
2.
If an old thermostat is being replaced and is in a
satisfactory location and the wiring appears to be
in good condition, use existing wiring. If in doubt, use
new wire.
3.
If a new location is chosen or if this is a new
installation, thermostat cable must first be run to
the location selected. All wiring must agree with
local codes and ordinances. These instructions cover
bringing the wire down from the attic but it can be
run from a basement or crawl space using similar
methods. Refer to Figure 24.
4. Before drilling a hole in the wall at selected location,
drive a small finishing nail through the ceiling in
the corner of the wall and ceiling above the
thermostat location. Pull the nail out and push a small
stiff wire through the hole so it can be found in the
attic. Drill a 1/2 inch hole through the ceiling wall plate.
5.
Probe for obstructions in the partition. Then drill a
1/2 inch hole through wall at the selected location
for thermostat.
FIGURE 24 - ROUTE THERMOSTAT CABLE
NOTE: Use heavier wire size if more than 20 ft. of
wire is required
20
COUNTERFLOW TOP VENT GAS WALL HEATER
6.
From the attic, feed the thermostat cable or a stiff wire
through wall until even with thermostat location.
7.
Snag thermostat cable through hole and pull cable
through hole in wall so that 6 inches of cable protrudes.
8. Route cable to wall furnace.
MOUNTING THE THERMOSTAT
1.
To remove thermostat cover, squeeze both sides
and lift. Carefully remove and discard the packing tab
protecting the switch contacts See. Figure 25.
2.
Connect the thermostat wires to the terminal screws
on the thermostat base.
3.
Push any excess wire back through hole in wall and
plug hole with insulation to prevent drafts from
affecting thermostat operation.
4. Being sure to level the thermostat for best
appearance, fasten the thermostat base to the wall
through mounting holes with screws provided.
5.
Replace the thermostat cover.
FIGURE 25 - THERMOSTAT
SQUEEZE FIRLY BOTH SIDES AND LIFT TO REMOVE COVER
Publicidad
