Publicidad
Idiomas disponibles
Idiomas disponibles
HARDWIRE ACCESSORY 9940
Installation Instructions
THIS KIT IS FOR USE WITH MODELS:
CF351E/CF352E/CF501E/CF502E
WARNING: Danger of bodily injury. Turn off
electric power supply at disconnect switch, fuse box or
service panel before working on the furnace.
SUMMARY: This accessory converts the Cozy Counterflow
furnaces using the electric service cord provided, to a
hardwired, permanent electrical connection.
If this furnace is equipped or has been previously installed
and operated using the service power cord, disconnect the
26
COUNTERFLOW TOP VENT GAS WALL HEATER
cord at the receptacle connector located at the base of the
furnace and remove the cord completely from the furnace.
Following the wiring diagram below, make all the
necessary wiring connections from an outside electrical
source. All electrical work must conform to your local
codes and ordinances or in their absence, with National
Electrical Code, ANSI/NFPA 70 or in Canada, Canadian
Electrical Code C22.1. If you are not familiar with wiring
codes in general, have a competent electrician do this job.
Be sure this accessory is of the type and design required
for use with your furnace.
A single speed motor is shown in the wiring diagram
below. The required field wiring connections are
applicable to all models listed above. For internal wiring
connections to your model, refer to the wiring diagram
attached to the furnace.
Publicidad
