Service Information - Stanley STGL2218 Manual De Instrucciones

f Rotate the gear case till it reaches its ideal location.
f Tighten the four screws on the gear case.
f Ensure that the rotating mechanism is locked.
Warning! Do NOT use the tool when the gear case is
unlocked.
APPLICATION ON METALS
When applying the tool on metals, make sure that a
residual-current device (RCD) is inserted to prevent
danger from metal chips.
If the RCD causes power disconnection, have the tool sent
to an authorized Stanley dealer for repair.
Warning! Under extreme working conditions,
conductive dust and grit may accumulate on the housing
interior when handling metal workpieces. This could create
an electric shock hazard as it weakens the protective
insulation in the grinder.
To avoid accumulation of metal chips in the interior of the
grinder, we recommend cleaning the ventilation ducts
daily. Refer to Maintenance.
USING GRINDING WHEELS
Warning! Metal powder accumulates. Excessive
use of the grinding wheel on metals may increase the
risk of electric shock. To reduce the risk, insert the RCD
before use and clean the ventilation ducts daily. Follow the
maintenance instructions below to blow dry compressed
air into the ventilation ducts.
MAINTENANCE
STANLEY power tools have been designed to operate
over a long period of time with minimal maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Warning! To minimize the danger of serious
personal injury, please switch off the tool power and
disconnect all plugs before adjusting or removing/
installing any accessory. Before reassembling the tool,
press and release the trigger switch to make sure the tool
is already switched off.
LUBRICATION
This power tool does not require separate lubrication.
CLEANING
Warning! Once visible dust accumulates on the
ventilation ducts and the surrounding, immediately use dry
air to blow away dust and grit out of the interior of the
housing. You need to wear approved eye and facial
protective gear when performing this process.
Warning! Never use solvents or harsh chemicals to
clean non-metal parts of the tool. These chemicals may
weaken the materialoftheparts.Useonlymildsoap and
damp cloth to clean the tool. Never let any liquid get inside
the tool; never immerse any part of the tool into liquid.
ACCESSORIES
The performance of your tool depends on the accessory
used. STANLEY accessories are engineered to
high quality standards and designed to enhance the
performance of your tool. By using these accessories you
will get the very best from your tool.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your STANLEY
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.

SERVICE INFORMATION

STANLEY offers a full network of company-owned and
authorized service locations. All STANLEY Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service.
For more information about our authorized service
centers and if you need technical advice, repair,
or genuine factory replacement parts, contact the
STANLEY location nearest you.
SPECIFICATIONS
Input power
No-load speed/
rated speed
Wheel diameter
Grinding wheels thickness
Type of wheel
Spindle diameter
Weight
ENGLISH • 23
STGL2218 STGL2223
2200W
8500/min (rpm) 6500/min (rpm)
7" (180mm) 9" (230mm)
6,6mm
27
5/8-11 / M14 5/8-11 / M14
5,9kg
2200W
6,6mm
27
6kg