Replacing The Device Fuse; Replacing The Light Bulb - Dometic COOLFREEZE CF80 Instrucciones De Uso

Operation
6.9

Replacing the device fuse

!
WARNING! Danger of electrocution!
Disconnect the connection cable before you replace the device fuse.
➤ Pull off the connection cable.
➤ Pry out the fuse insert (fig. 3 2, page 3) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating (T2.5AL250V).
➤ Press the fuse insert back into the housing.
6.10

Replacing the light bulb

➤ Press the switch pin (fig. 8 2, page 5) downwards so that the transparent part
(fig. 8 1, page 5) of the lamp can be removed at the front.
➤ Replace the light bulb.
I
NOTE
The LEDs in the light bulb must be aligned with the transparent part of
the lamp.
➤ Press the transparent part of the lamp back into the housing.
18
CoolFreeze
EN