Nemox gelatissimo exclusive i-green Instrucciones De Uso página 20

Lift it up and CHECK THAT THE
E X T E R N A L W A L L O F T H E
REMOVABLE BOWL IS ALL WET,
otherwise the machine will not cool
properly.
Insert the mixing blade for a removable
bowl (F)
Tighten the fixing knob (C).
The machine is ready for use
ATTENTION!:
when using a saline solution, once you
have finished using the machine,
thoroughly wash and dry both the fixed
and removable bowls to prevent
corrosion. Do not leave the saline
solution inside the bowl!
M A K I N G I C E C R E A M W I T H
GELATISSIMO EXCLUSIVE I-GREEN
How to proceed:
Ensure that the voltage indicated on the
data plate matches the mains voltage.
Insert the power plug into the socket.
Press the main switch (N) and then the
switch (L) to start the cooling cycle. Pre-
cool the bowl for 5 minutes.
Pour the mixture.
Place the transparent cover (D).
Press the switch (M) to start the mixing
blade.
When the ice cream reaches the
intended consistency, stop the machine
by pressing all the buttons and remove
the ice cream.
When you have used the fixed bowl and
want to extract the ice cream, remove as
much as possible with the spatula (E) or
a plastic or wooden utensil. Remove the
ring (O) and then the blade (B). Reinsert
the ring (O) before removing the ice
cream left in the bowl. This step prevents
the ice cream or other ingredients from
20
E E n n g g l l i i s s h h
infiltrating under the seal and therefore,
into the machine.
Another ice cream can be prepared after
a brief standby time (approx. 10
minutes), by repeating the steps
described.
After use, turn off the switch (S) and
disconnect the machine from the mains.
WHAT DO YOU NEED TO MAKE A
GOOD ICE CREAM OR SORBET?
Making a good, healthy and natural
ice cream or sorbet, with the right
consistency, depends on various
factors; here are a few suggestions:
An appliance that is in good working
order: leave enough space on the
counter to allow air to circulate freely.
Air is needed to cool the compressor.
Good, fresh and well balanced
ingredients must be used.
A successful recipe is a mixture of
top quality ingredients and excellent
machine efficiency.
Serve the preparation in pre-cooled
containers.
CLEANING THE MACHINE
Make sure the machine is turned off
(check the main power switch) and
unplugged before carrying out any
cleaning.
Wash the blades (B) and (F), the
transparent cover (D), the fixing knob
(C), the spatula (E), the ring (O) and the
removable bowl (G) with hot water and
soap. These parts can also be cleaned
in the dishwasher on a low temperature
cycle.