WEG CFW500 Manual Del Usuario página 37

Powering up and Startup
Seq Indication on the Display/Action
13
If necessary, modify the content of "P0407
„
- Motor Rated Power Factor", or press the
key for the next parameter
During the Self-Adjustment the HMI will
„
15
simultaneously indicate the status of "RUN"
and "CONF". And the bar graph indicates
the progress of the operation
And the bar graph indicates the progress
„
of the operation. The Self-Adjustment can
be interrupted at any time by means of the
key
17
The result of Self-Adjustment is the value in
„
ohms of the motor stator resistance shown
in P0409
This is the last parameter of the Self-
„
Adjustment of the V V W control mode.
Press the key
parameter P0202
19
Through the keys
„
desired menu or press the key BACK/ESC
again to return directly to the monitoring
mode of the HMI
Figure 5.3: Sequence of the startup group for V V W control
32 | CFW500
Seq
14
16
18
to return to initial
and , select the
Indication on the Display/Action
At this point, the HMI shows the option to
„
do the self-adjustment. Whenever possible,
perform the self-adjustment. Thus, to
activate the self-adjustment, change the
value of P0408 to "1"
At the end of the Self-Adjustment, the value
„
of P0408 automatically returns to "0", as
well as the Status of "RUN" and "CONF"
are cleared
Press the key for the next parameter
„
To exit the STARTUP menu, just press
„
BACK/ESC