geberit Preda Manual De Mantenimiento página 33

Make settings with the Geberit App
After connecting a Geberit app to the device, the following functions and settings are available:
• Operation:
– Flushing: Activating a flush
– Cleaning: Suppressing the flush actuation for a few minutes
• Setting parameters and functions → See the 'Settings' table
• Displaying device information such as the battery capacity or firmware version → See the 'Information'
table
• Displaying statistical values for use → See the 'Information' table
• Exporting device information and statistical values
• Displaying error messages
• Carrying out firmware updates
• Saving and transferring presettings
The settings can be saved in the Geberit App as presettings and transferred to other devices.
Table 3: Settings
Menu item Description
Operation
Actuate flush
[Flush]
Actuates a flush.
Activate cleaning mode
The flush actuation is suppressed
for the [cleaning time]. A short
signal tone sounds every
[Cleaning]
4 seconds. The urinal flushes at
the end of the [cleaning time].
[Cleaning time]
Device settings
Block flush
The flush actuation is blocked for
[Block flush] 10 hours. 2 short signal tones
command sound every minute. The function
switches off automatically after
10 hours.
Empty pipe
The solenoid valve is opened for
[Empty pipe]
30 minutes to empty the pipe.
command 2 short signal tones sound every
minute. The function switches off
automatically after 30 minutes.
90071995661314699 © 11-2022
970.650.00.0(01)
Application
• To run a function test
on the solenoid valve
• To flush out the urinal
ceramic (e.g. when
setting the flush time)
• To clean the cover
plate and urinal
ceramic without the
water running
–
• To carry out
maintenance work
• To carry out
maintenance work
• To carry out winter
emptying
Area Factory
setting
On/Off –
On/Off –
1–20 min 10 min
On/Off –
On/Off –
33
EN